- Notes, cautions, and warnings
- Before working inside your computer
- After working inside your computer
- Safety instructions
- Recommended tools
- Screw list
- Removing the base cover
- Replacing the base cover
- Removing the battery
- Replacing the battery
- Removing the coin-cell battery
- Replacing the coin-cell battery
- Removing the memory modules
- Replacing the memory modules
- Removing the solid-state drive
- Replacing the solid-state drive
- Removing the hard drive
- Replacing the hard drive
- Removing the heat sink
- Replacing the heat sink
- Removing the fan
- Replacing the fan
- Removing the speakers
- Replacing the speakers
- Removing the I/O board
- Replacing the I/O board
- Removing the power-adapter port
- Replacing the power-adapter port
- Removing the wireless card
- Replacing the wireless card
- Removing the display assembly
- Replacing the display assembly
- Removing the power button with fingerprint reader
- Replacing the power button with fingerprint reader
- Removing the system board
- Replacing the system board
- Removing the touchpad
- Replacing the touchpad
- Removing the palm-rest and keyboard assembly
- Replacing the palm-rest and keyboard assembly
- Device drivers
- System setup
- Troubleshooting
- Getting help and contacting Dell
Inspiron 5485 2-in-1 Service Manual
Entering BIOS setup program
Turn on (or restart) your computer, and then press F2 immediately.
NOTE If you wait too long and the Dell logo appears, continue
to wait until you see the desktop. Then, turn off your computer and
try again.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\