Inspiron 5406 2-in-1 Service Manual

Installing the power-adapter port

If you are replacing a component, remove the existing component before performing the installation procedure.

The following image indicates the location of the power-adapter port and provides a visual representation of the installation procedure.

Image: Installing the power-adapter port

Place the power-adapter port into the slot on the palm-rest and keyboard assembly.
Replace the screw (M2x3) that secures the power-adapter port to the palm-rest and keyboard assembly.
Route the power-adapter port cable through the routing guide on the palm-rest and keyboard assembly.
Connect the power-adapter port cable to the system board.
Adhere the tape that secures the power-adapter port cable to the system board.
Close the right display-hinge.
Replace the three screws (M2.5x5) that secure the right display-hinge to the palm-rest and keyboard assembly.