Integrated Dell Remote Access Controller 9 RACADM CLI Guide

testtrap

Table 1. Details of testtrapThe following table provides details about the testtrap subcommand:
Description	Tests the RAC’s SNMP trap alerting feature by sending a test trap from iDRAC to a specified destination trap listener on the network. To run this subcommand, you must have the Test Alert permission. NOTE: Before you run the testtrap subcommand, make sure that the specified index in the RACADM iDRAC.SNMPAlert group is configured properly. The indices of testtrap subcommand is co-related to the indices of iDRAC.SNMPAlert group.
Synopsis	racadm testtrap -i <index>
Input	-i <index> — Specifies the index of the trap configuration that must be used for the test. Valid values are from 1 to 4.
Example	Enable the alert. racadm set idrac.emailalert.1.CustomMsg 1 racadm set iDRAC.SNMPAlert.1.Enable 1 Set the destination email IP address. racadm set iDRAC.SNMPAlert.1.Destination 192.168.0 View the current test trap settings. racadm get iDRAC.SNMPAlert.<index> where <index> is a number from 1 to 8