Integrated Dell Remote Access Controller 8 (iDRAC8) and iDRAC7 Version 2.10.10.10 RACADM Command Line Interface Reference Guide

testtrap

Description	Tests the RAC’s SNMP trap alerting feature by sending a test trap from CMC to a specified destination trap listener on the network. To run this subcommand, you must have the Test Alert permission. NOTE: Before you run the `testtrap` subcommand, make sure that the specified index in the `RACADM iDRAC.SNMP.Alert` group is configured properly. The indices of `testtrap` subcommand is co-related to the indices of iDRAC.SNMP.Alert group. NOTE: Before you run the `testtrap` subcommand, make sure that the specified index in the cfgAlerting group is configured properly.
Synopsis	racadm testtrap -i <index>
Input	`-i <index>` — Specifies the index of the trap configuration that must be used for the test. Valid values are from 1 to 4.
Example	Enable the alert. racadm set idrac.emailalert.1.CustomMsg racadm set iDRAC.SNMP.Alert.1.Enable Set the destination email IP address. racadm set iDRAC.SNMP.Alert.1.DestIpAddr 192.168.0 View the current test trap settings. racadm get iDRAC.SNMP.Alert.<index> where `<index>` is a number from 1 to 8 Send a test trap to the destination configured for index 1: racadm testtrap -i 1