Integrated Dell Remote Access Controller 8 (iDRAC8) and iDRAC7 Version 2.10.10.10 RACADM Command Line Interface Reference Guide

sensorsettings

Description	Allows you to perform threshold settings of the sensor. To run this subcommand, you must have Configure iDRAC privilege. NOTE: An error message is displayed when the following is performed: A set operation is performed on an unsupported FQDD. Out of range settings is entered. Invalid sensor FQDD is entered. Invalid threshold level filter is entered.
Synopsis	racadm sensorsettings set <FQDD> -level Min <value>
Input	`<FQDD>` — Sensor or corresponding sensor FQDD which needs a threshold configuration. Run the command, `racadm getsensorinfo` to view the sensor FQDD. The `R/W` field in the output getsensorinfo indicates if the sensor thresholds can be configured. Replace the `<FQDD>` field with the corresponding sensor FQDD that needs a threshold configuration. `-level` — threshold level for the sensor setting. Values are `Max` or `Min`.
Examples	To set the minimum noncritical threshold level for a power sensor type. racadm sensorsettings set iDRAC.Embedded.1#SystemBoardCPUUsage -level Max 95 NOTE: The entered value must be lesser or higher than the sensor critical threshold limit.