Integrated Dell Remote Access Controller 8 (iDRAC8) and iDRAC7 Version 2.10.10.10 RACADM Command Line Interface Reference Guide

getniccfg

Description

Displays the current and static NIC settings for iDRAC.

Displays the current NIC settings.

Synopsis

racadm getniccfg [-m <module>]

Input

–m <module> must be one of the following values:

chassis : Default state if -m is not specified.
server-<n> : where n=1–16
server-<nx> : where n=1–8; x = a, b, c, d (lower case)
switch-<n> : where n=1–6

Output

The getniccfg subcommand displays an appropriate error message if the operation is not successful. Otherwise, the output is displayed in the following format:

`NIC Enabled`	`=1`
`IPv4 Enabled`	`=1`
`DHCP Enabled`	`=1`
`Static IP Address`	`=192.168.0.120`
`Static Subnet Mask`	`=255.255.255.0`
`Static Gateway`	`=192.168.0.1`
`Current IP Address`	`=192.168.0.32`
`Current Subnet Mask`	`=255.255.255.0`
`Current Gateway`	`=192.168.0.1`
`IPv6 Enabled`	`=0`
`Autoconfiguration Enabled`	`=1`
`Static IPv6 Address`	`=::`
`Static IPv6 Gateway`	`=::`
`Link Local Address`	`=::`
`Current IPv6 Address 1`	`=::`
`Current IPv6 Gateway`	`=::`
`Speed`	`=Autonegotiate`
`Duplex`	`=Autonegotiate`
`Redundant mode`	`=0`
`VLAN Enable`	`=0`
`VLAN ID`	`=1`
`VLAN priority`	`=0`

NOTE: IPv6 information is displayed only if IPv6 is enabled in iDRAC.

NOTE: LOM Status is displayed only for iDRAC on Rack and Tower servers and is not displayed for iDRAC Enterprise on Blade servers.

Example

Display CMC network settings

racadm getniccfg -m chassis

Display iDRAC network settings in server slot 1
```
racadm getniccfg -m server-1
```

Welcome

Welcome to Dell

Integrated Dell Remote Access Controller 8 (iDRAC8) and iDRAC7 Version 2.10.10.10 RACADM Command Line Interface Reference Guide

getniccfg

Rate this content