Dell iDRAC Service Module 5.3.0.0 Release Notes
Limitations on all supported operating systems
The table lists the limitations in
iDRAC Service Module 5.3.0.0 that are common on all supported operating systems.
| Issue ID | Functional area | Description |
|---|---|---|
|
158667 159019 158514 158740 |
Interruption in communication between iDRAC and iSM | When the workload on the host increases due to intensive task requests by the processor, the communication between iDRAC Service Module and iDRAC is interrupted for a moment and restored automatically. |
| Not available | iDRAC to OMSA SNMP alert mapping | iDRAC to OMSA SNMP alert mapping is enabled when OMSA is running. To disable iSM Host SNMP OMSA alert, restart the iDRAC Service Module. |
| 214305 | Enable-iDRACAccessHostRoute tool | While performing feature enablement using the Enable-iDRACAccessHostRoute tool, if there are no free slots in the ManualDNSEntry parameter in iDRAC and the operating system IP address is not updated in ManualDNSEntry, then the OS to iDRAC Pass-through feature does not function. |
| 279015 | Network interface monitoring support through Redfish client | For all PowerEdge 14G servers, during the validation of Redfish attributes, the last letters of the value of Host name and FQDN are not displayed. |
| 277931 | iSM command-line utility | While starting or restarting iSM, it may take up to 180 seconds for the iSM CLI utility to start functioning because the dependent libraries may take some time to initiate. |
| Not available | Metric Injection (Host OS Telemetry) | The Metric Injection (Host OS Telemetry) feature supports a maximum of 48 metric values on iDRAC firmware 7.00.60.00 and earlier versions. |
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\