Uninstall Smart Scale services without removing metadata and deploy again.
Prerequisites
Redeploying Smart Scale services for the data center makes backup functionality unavailable. Pause jobs in the backup software before redeploying.
Before redeploying, make a list of the port groups and IP addresses that are configured on each Ethernet interface in the DD Namespace VM (DDNVM).
After redeployment, use this information to reconfigure (from the vCenter) each Ethernet interface with the appropriate port groups. Also verify associated IP addresses for each Ethernet interface. Wait 15 minutes for system pools to be operable. Providing incorrect port groups may cause unexpected behaviors (for example, an Ethernet interface may not work).
Steps
In the left side navigation panel, select
Infrastructure > Data Centers.
To expand the card view, click the arrow in the bottom-right corner of a data center that is running Smart Scale services.
Click
Actions, and select
Redeploy Services > Redeploy Services.
Enter a
Username and
Password, and click
Redeploy Services.
User must have vCenter deployment privileges.
Results
Redeploying services incorporates two steps: uninstalling services and deploying services. Two jobs appear on the
Jobs page. When the uninstall job finishes, the deploy job starts. The data center summary page shows "Uninstalling" first, followed by "Deploying," and then "Running" (if deployment is successful).
Deployment can take up to 30 minutes depending on network bandwidth, vCenter load, and other network configuration factors. Details can be viewed from
Health > Jobs.
If deployment fails, options exist to
Retry,
Cancel Deployment, or
Edit deployed Smart Scale services.
NOTE Clicking
Retry only prompts for vCenter credentials and is not an opportunity to update deployment configurations. Click
Cancel to restart the deployment wizard and make configuration changes.
Click
Edit deployed Smart Scale services to update the deployment configurations.
Next steps
After successful redeployment, access the vCenter, and reconnect the NICs on the DDNVM to the appropriate port groups. Wait 15 minutes before continuing data path operations.
Data is not available for the Topic
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\