After you have uploaded an update package, you can use it to update your DDMC software.
Prerequisites
A third disk with 100GB (using Hyper-V manager) must be added before updating to DDMC 7.6.
Click the setting menu of the VM.
Click
Add button to add a new hard drive.
Use the
New Virtual Hard Disk Wizard.
The new added disk should be 100GB.
Add the disk.
About this task
NOTE Software update files use the
.rpm file extension. This topic assumes that you are updating only DDMC. If you make hardware changes, such as adding, swapping, or moving interface cards, you must update the
DDOS configuration to correspond with the hardware changes.
Steps
Review the appropriate release notes for instructions for this update, and verifying available space.
NOTE For most releases, updates are permitted from up to two prior major release versions.
Click the
Settings button (the gear icon) in the DDMC banner, then select
System > UPDATE.
In the Update Packages Available area, select the update package from the list, and select
Perform System Update.
Monitor the update progress from the DDMC console page.
The update process automatically reboots DDMC.
It is recommended that you keep the System Update progress dialog open until the update completes or until the system powers off.
Data is not available for the Topic
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\