Dell PowerProtect DD Management Center (DDMC) 7.9 Installation and Administration Guide

Installing DDMC in a VMware environment

There are two procedures for installing the .ovf file and configuring settings for DDMC.

Here is a summary of the factory default settings and the settings that can be configured during the configuration procedure.

Table 1. Installation and configuration settings
Setting	Defaults
Name	Name for DDMC Virtual Machine (default is DDMC)
Hostname	Fully qualified hostname
Gateway IP Address	IP address of gateway server
Serial Number	Autogenerated
IP allocation policy	DHCP or fixed IP address. If fixed, supply the IP address, netmask, and gateway information.
DNS Servers	DNS primary and secondary server names (required). If only a primary is used at the site, type the primary name in the secondary field as well.
Mail Server	Mail server address for the site
Admin Email	Admin email address for the site
ASUP to Support	On (default) or Off
Alerts to Support	On (default) or Off
ASUP to Admin	On or Off (default)
Alerts to Admin	On or Off (default)
AM Email to Admin	On or Off (default)
Network Ports	eth0a – enabled for DHCP; eth0b – disabled
SSH, HTTPS	Enabled by default
ASUP and Alerts	autosupport@autosupport.datadomain.com
AM Email	Runs daily at 8 AM
ASUP	Runs daily at 6 AM
sysadmin password	See Logging into DDMC. After initial login, the change the password to meet the site security requirements. Do this step before you start adding Data Domain or PowerProtect systems.