You can change administrative information for both managed and unmanaged Tenant Units using the General tab in the Edit Tenant Unit dialog.
Steps
Select
Administration > Multitenancy.
Select a Tenant Unit in the tree, and select Edit Tenant Unit (yellow pencil) above the tree.
In the General tab, you can change the following:
Tenant Unit name
Administrator name
Administrator email – If the administrator email is modified, report templates sending reports that are associated with the Tenant Unit to that administrator must be re-routed. After editing the administrator email, a popup appears confirming whether a change must be made for all report templates that are associated with the old email. If you select Yes, all old administrator email messages are replaced with the new value.
Security Mode – You can choose to enable
strict security mode, which assures that any incoming replication is from another Tenant Unit that is owned by the same Tenant. In addition, this mode must be enabled to allow management connections to or from assigned IPs.
Management IP Addresses – You can add or delete management IP addresses for remote client addresses or local DDMC addresses.
Data is not available for the Topic
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\