- Notes, cautions, and warnings
- Working inside your computer
- Removing and installing components
- Inside view of your computer
- System-board components
- Recommended tools
- Screw list
- Left-side cover
- Light bar
- Front cover
- 2.5-inch hard drive
- 3.5-inch hard drive
- Chassis fan
- Memory modules
- Wireless card
- Solid-state drive/Intel Optane
- Graphics card
- Coin-cell battery
- Power-supply unit
- Processor fan and heat-sink assembly
- Processor
- VR heat sink
- LED daughter board
- System board
- Device drivers
- System setup
- Troubleshooting
- Getting help and contacting Dell
G5 5090 Service Manual
Installing the light bar
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following images indicate the location of the light bar and provides a visual representation of the installation procedure.
Steps
- Align and slide the tabs on the light bar into the slot on the chassis.
- Replace the screw (#6-32) that secures the light bar to the chassis.
- Connect the light bar cable to its connector on the system board.
Next steps
- Install the left-side cover.
- Follow the procedure in After working inside your computer.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\