Dell G5 5590 Service Manual

Procedure

1. Loosen the two captive screws on the base cover.
2. Remove the seven screws (M2x4) that secure the base cover to the palm-rest assembly.
   NOTE:The two captive screws when released will create a gap which can be used to pry and lift the base cover off the palm-rest assembly.

   
3. Pry the base cover from the rear side using a plastic scribe.
4. Pry the base cover from the tabs on the palm-rest assembly and lift the base cover off the palm-rest assembly.
   
   NOTE:The following steps are applicable only if you want to further remove any other component from your computer.
5. Using the pull tab, disconnect the battery cable from the system board.
   
6. Press and hold the power button for 5 seconds to ground the computer and drain the flea power.