- Notes, cautions, and warnings
- Views of Dell G15 5535
- Set up your Dell G15 5535
- Specifications of Dell G15 5535
- Working inside your computer
- Removing and installing Customer Replaceable Units (CRUs)
- Removing and installing Field Replaceable Units (FRUs)
- Software
- Technology and components
- BIOS Setup
- Troubleshooting
- Handling swollen rechargeable Li-ion batteries
- Locate the Service Tag or Express Service Code of your Dell computer
- Dell SupportAssist Pre-boot System Performance Check diagnostics
- Built-in self-test (BIST)
- System-diagnostic lights
- Recovering the operating system
- Real-Time Clock (RTC Reset)
- Backup media and recovery options
- Wi-Fi power cycle
- Drain residual flea power (perform hard reset)
- Getting help and contacting Dell
Dell G15 5535 Owner's Manual
Removing the ethernet and audio board
Prerequisites
About this task
The following image indicates the location of the ethernet and audio board and provides a visual representation of the removal procedure.
- Follow the procedure in Before working inside your computer.
- Remove the base cover.
- Remove the battery.
- Remove the rear cover.
- Remove the solid-state drive.
- Remove the wireless card.
- Remove the memory module.
- Remove the system board.NOTE:The system board can be removed as an assembly with the fan and heat-sink assembly, ethernet and audio board, and USB board attached.
Steps
- Turn the system-board assembly over.
- Remove the two screws (M2x4) that secure the ethernet and audio board to the system board.
- Disconnect and remove the ethernet and audio board from the system board.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\