Dell G15 5535 Owner's Manual

Removing the display assembly

1. Peel that tape that secures the display-cable latch to the system board.
2. Open the latch and disconnect the display cable from the system board.
3. Disconnect the dynamic-display switch (DDS) cable from the system board.
   NOTE:This step is applicable only for computers that are shipped with a 165 Hz or 240 Hz display.
4. Remove the antenna cables from the routing guides on the right fan.
5. Turn the computer over and place the computer on a clean and flat surface.
6. Remove the four screws (M2.5x4) that secure the left display-assembly hinge to the palm-rest and keyboard assembly.
7. Remove the antenna cables from the routing guides along the left edge of the palm-rest and keyboard assembly.
8. Remove the four screws (M2.5x4) that secure the right display-assembly hinge to the palm-rest and keyboard assembly.
9. Remove the display cable from the routing guides along the right edge of the palm-rest and keyboard assembly.
10. Gently lift the display assembly from the palm-rest and keyboard assembly.