- Notes, cautions, and warnings
- Views of Dell G15 5535
- Set up your Dell G15 5535
- Specifications of Dell G15 5535
- Working inside your computer
- Removing and installing Customer Replaceable Units (CRUs)
- Removing and installing Field Replaceable Units (FRUs)
- Software
- Technology and components
- BIOS Setup
- Troubleshooting
- Handling swollen rechargeable Li-ion batteries
- Locate the Service Tag or Express Service Code of your Dell computer
- Dell SupportAssist Pre-boot System Performance Check diagnostics
- Built-in self-test (BIST)
- System-diagnostic lights
- Recovering the operating system
- Real-Time Clock (RTC Reset)
- Backup media and recovery options
- Wi-Fi power cycle
- Drain residual flea power (perform hard reset)
- Getting help and contacting Dell
Dell G15 5535 Owner's Manual
Installing the power button
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following image indicates the location of the power button and provides a visual representation of the installation procedure.
Steps
- Place the power button on the slot on the palm-rest and keyboard assembly.
- Replace the screw (M2x2) that secures the power button to the palm-rest and keyboard assembly.
- Align the screw holes on the power-button board assembly with the screw holes on the palm-rest and keyboard assembly.
- Replace the two screws (M2x2) that secure the power-button board assembly to the palm-rest and keyboard assembly.
Next steps
- Install the system board.
- Install the memory module.
- Install the wireless card.
- Install the solid-state drive.
- Install the rear cover.
- Install the battery.
- Install the base cover.
- Follow the procedure in After working inside your computer.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\