- Notes, cautions, and warnings
- Views of Dell G15 5530
- Set up your Dell G15 5530
- Specifications of Dell G15 5530
- Working inside your computer
- Removing and installing Customer Replaceable Units (CRUs)
- Removing and installing Field Replaceable Units (FRUs)
- Software
- BIOS Setup
- Troubleshooting
- Handling swollen rechargeable Li-ion batteries
- Locating the Service Tag or Express Service Code of your Dell computer
- Dell SupportAssist Pre-boot System Performance Check diagnostics
- Built-in self-test (BIST)
- System-diagnostic lights
- Recovering the operating system
- Real-Time Clock (RTC Reset)
- Backup media and recovery options
- Network power cycle
- Drain flea power (perform hard reset)
- Getting help and contacting Dell
Dell G15 5530 Owner's Manual
Removing the touchpad
Prerequisites
- Follow the procedure in Before working inside your computer.
- Remove the base cover.
- Remove the battery.
About this task
The following image indicates the location of the touchpad and provides a visual representation of the removal procedure.
Steps
- Open the latch and disconnect the touchpad cable from the system board.
- Remove the three (M2x2) screws that secure the touchpad bracket to the palm-rest and keyboard assembly.
- Lift the touchpad bracket off the touchpad.
- Remove the four (M2x2) screws that secure the touchpad to the palm-rest and keyboard assembly.
- Lift the touchpad off the palm-rest and keyboard assembly.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\