Removing I/O board - shipped with M.2 connector
Prerequisites
For computers shipped with NVIDIA GeForce RTX 3050, and
NVIDIA GeForce RTX 3050 Ti
- Follow the procedure in Before working inside your computer.
- Remove the base cover.
- Remove the battery.
- Remove the rear cover.
- Remove the solid-state drive 1.
- Remove the solid-state drive 2.
- Remove the wireless card.
- Remove the memory module.
- Remove the
system board.
NOTE System board can be removed with the heat sink, I/O board, and USB board attached.
About this task
The following image indicates the location of the I/O board on computers shipped with NVIDIA GeForce RTX 3050, and NVIDIA GeForce RTX 3050 Ti and provides a visual representation of the removal procedure.
![Image: Removing the I/O board](https://dl.dell.com/content/guides/public/html//dell-g15-5511-service-manual/images/GUID-74CAD129-90C4-4CCB-90C1-835A93A0502C-low.jpg)
Steps
- Turn the system board over.
- Remove the two screws (M2x4) that secure the I/O board to the system board.
- Remove the I/O board from the system board.