Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Enjoy members-only rewards and discounts
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Sign In Create an Account Dell Financial Services Premier Sign In Partner Program Sign In
Contact Us

Your Dell.com Carts

Dell G5 SE 5505 Service Manual

PDF

Installing the 2230 solid-state drive in M.2 slot one

Prerequisites

If you are replacing a component, remove the existing component before performing the installation procedure.

About this task

NOTE This procedure applies only to computers shipped with a 2230 solid-state drive installed in M.2 slot one.
NOTE Depending on the configuration ordered, your computer may be shipped with one of the following:
  • One hard drive and one 2230 or 2280 solid-state drive
  • One 2230 solid-state drive and one 2280 solid-state drive
NOTE Depending on the configuration ordered, your computer may support either 2230 solid-state drive or 2280 solid-state drive in M.2 slot one.
NOTE Install the solid-state drive thermal shield, if it is not installed.

The following image indicates the location of the 2230 solid-state drive that is installed in M.2 slot one and provides a visual representation of the installation procedure.

Image: Installing the solid-state drive

Steps

  1. Slide the solid-state drive mounting bracket into the slot on the system board, if it is not installed.
  2. Align the notches on the solid-state drive with the SSD1 slot on the system board.
  3. Slide the solid-state drive into the SSD1 slot on the system board.
  4. Replace the screw (M2x3) that secures the solid-state drive to the system board.
  5. Place the thermal shield on the solid-state drive.
  6. Align the screw holes on the thermal shield with the screw holes on the system board and the palm-rest and keyboard assembly.
  7. Replace the two screws (M2x3) that secure the thermal shield to the solid-state drive and the system board.

Next steps

  1. Install the base cover.
  2. Follow the procedure in After working inside your computer.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\