Skip to main content
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Enjoy members-only rewards and discounts
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.

Dell G5 SE 5505 Service Manual

Removing the 2230 solid-state drive in M.2 slot one

Prerequisites

  1. Follow the procedure in Before working inside your computer.
  2. Remove the base cover.

About this task

NOTE This procedure applies only to computers shipped with a 2230 solid-state drive installed in M.2 slot one.
NOTE Depending on the configuration ordered, your computer may be shipped with one of the following:
  • One hard drive and one 2230 or 2280 solid-state drive
  • One 2230 solid-state drive and one 2280 solid-state drive
NOTE Depending on the configuration ordered, your computer may support either 2230 solid-state drive or 2280 solid-state drive in M.2 slot one.

The following image indicates the location of the 2230 solid-state drive that is installed in M.2 slot one and provides a visual representation of the removal procedure.

Image: Removing the solid-state drive

Steps

  1. Remove the two screws (M2x3) that secure the thermal shield to the solid-state drive and the system board.
  2. Lift the thermal shield off the palm-rest and keyboard assembly.
  3. Remove the screw (M2x3) that secures the solid-state drive to the palm-rest and keyboard assembly.
  4. Slide and lift the solid-state drive off the SSD1 slot on the system board.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\