Skip to main content
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Enjoy members-only rewards and discounts
  • Create and access a list of your products

Dell G3 3590 Service Manual

Installing the system board

Prerequisites

If you are replacing a component, remove the existing component before performing the installation procedure.

About this task

The following image indicates the location of the system board and provides a visual representation of the installation procedure.
NOTE

The I/O board connector is located underneath the system board. Turn the system board over and connect the I/O board cable to the system board.

Image: Installing the system board

Image: Installing the system board

Steps

  1. Connect the I/O board cable to the system board.
  2. Turn the system board to the front and align and place the system board on the palm-rest and keyboard assembly.
  3. Connect the speaker cable to the system board.
  4. Open the latch and connect the keyboard cable to the system board.
  5. Open the latch and connect the battery cable to the system board.
  6. Open the latch and connect the power-button cable to the system board.
  7. Open the latch and connect the hard drive cable to the system board.
  8. Replace the two (M2x2) screws that secure the system board to the palm-rest and keyboard assembly.

Next steps

  1. Install the power-adapter port.
  2. Install the display assembly.
  3. Install the heat sink.
  4. Install the left fan.
  5. Install the right fan.
  6. Install the WLAN card.
  7. Install the solid-state drive/Intel Optane memory module.
  8. Install the battery.
  9. Install the base cover.
  10. Follow the procedure in After working inside your computer.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\