Dell G3 3590 Service Manual

Installing the base cover

If you are replacing a component, remove the existing component before performing the installation procedure.

The following image indicates the location of the base cover and provides a visual representation of the installation procedure.

Image: Connecting the battery cable

Image: Installing the base cover

Connect the battery cable to the system board if it is not already connected.
Place the base cover on the palm-rest and keyboard assembly, and snap the base cover into place.
Replace the six screws (M2x7) that secure the base cover to the palm-rest and keyboard assembly.
Tighten the four captive screws that secure the base cover to the palm-rest and keyboard assembly.