Connecting a
Host With HBAs to a PS Series Group on a Dedicated Network
If your host
system uses HBAs on a dedicated network to access your PS Series groups,
configure ASM/ME to register the discovery address using only these
HBAs. In the ASM/ME GUI, click Settings → PS Group Access. Select the checkbox for Use
Host Bus Adapters when you configure the PS Series group
access. This checkbox appears only if the HIT host has HBAs installed,
or an initiator other than the default software initiator.
If a HIT host has HBAs and default network interfaces,
the iSCSI traffic is restricted to only the HBA network interfaces,
and you select the checkbox to verify the connection to the group,
you might see the following error:
Error saving PS Group group_name: Specified group WKAddress is not reachable.
If the Verify connection checkbox
is not selected, ASM will add the new group entry but subsequent attempts
to edit it will fail. With the Use Host Bus Adapters option set, if the ping test fails, ASM will ignore the failure
and attempt to register the new PS Series group. If one HBA succeeds,
the group is added.
Data is not available for the Topic
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\