After you replace a
DDprotection storage system, you can use the
PowerProtect Data Manager UI to update the required storage settings in
PowerProtect Data Manager for the replacement storage. Only the
Administrator role can update the
protection storage settings in
PowerProtect Data Manager. This process only applies to stand-alone
DD systems, which are
DD systems not managed by
DDMC.
The replacement of a
DDprotection storage system that is used with
PowerProtect Data Manager can involve either of the following use cases:
You perform a
DD controller upgrade or head swap that replaces the
protection storage system without requiring the migration of data.
You perform collection replication or
DD Cloud migration to migrate data from the original
DD system to a new replacement system with the same or higher capacity.
CAUTION:The replacement
DD system must have all the storage units,
DD Boost users, and data that existed on the original
DD system.
After you replace the
DD system, ensure that you meet the following requirements before using the
PowerProtect Data Manager UI to update the storage settings:
All the protection policies that use the
DD storage system are disabled.
All the running protection jobs are completed.
All the required data has been manually migrated as needed from the original
DD system to the replacement
DD system.
Use one of the following procedures to update the
protection storage settings in
PowerProtect Data Manager after replacing the
DD storage system.
Updating the storage settings when data IP addresses are unchanged
Use the following procedure if you replaced the
DD storage system and none of the network settings or data IP addresses have changed.
From the left navigation pane, select
Infrastructure > Storage.
The
Storage window appears.
On the
Protection Storage tab, select the
DD and then click
Discover.
PowerProtect Data Manager automatically discovers the replacement
DD system and updates the storage settings for the replacement system. After discovery, the replacement
DD attributes appear on the
Protection Storage tab of the
Infrastructure > Storage window.
Updating the storage settings when data IP addresses are changed
Use the following procedure if you replaced the
DD storage system and any of the network settings or data IP addresses have changed.
NOTE:When data IP addresses have changed, update the network interface information for the replacement
DD system.
From the left navigation pane, select
Infrastructure > Storage.
The
Storage window appears.
On the
Protection Storage tab, select the
DD and then select
More Actions > Replace System.
Review the warning message about policies and running jobs, and then click
Continue.
In the
Replace System dialog box, specify the replacement
DD system settings and then click
Apply:
In the
Address field, specify the
DD system management address as the fully qualified domain name (FQDN) or IP address.
In the
Port field, specify the port for SSL communication. The default port is 3009.
Under
Host Credentials, select a new set of credentials or click
Add.
If a trusted certificate does not exist for the storage system, a dialog box appears requesting certificate approval. Click
Verify to review the certificate, and then click
Accept.
Under
Network Mapping, specify the replacement data IP address for each listed data IP address that has changed.
A system job is created for updating the storage settings for the replacement
DD system. You can monitor the system job in the
System Jobs window.
NOTE:
You must wait until the replacement system job completes before you perform any
PowerProtect Data Manager operations that use the
DD system being replaced.
After the system job completes, the replacement
DD attributes appear on the
Protection Storage tab of the
Infrastructure > Storage window. The protection policies that use the
DD system are automatically updated with the replacement
DD settings.
Data is not available for the Topic
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\