- Notes, cautions, and warnings
- Preface
- PowerProtect Data Manager for Network-Attached Storage Overview
- PowerProtect Data Manager overview
- Additional procedures for system administrators
- NAS appliance protection prerequisites
- NAS protection limitations
- Resolved limitations
- NAS protection deployment recommendations
- Encryption in-flight
- Roadmap for NAS protection
- Multiple VLAN support for NAS
- Supported Internet Protocol versions
- Security configuration
- Slicer library for high-density file system
- Managing Assets and Protection
- About NAS protection
- Enable the NAS asset source
- Add a NAS appliance
- Add a NAS share
- Assets configuration support for DNAS
- Edit or delete a NAS asset source
- Discovering and adding PowerScale configured with SmartConnect and multiple access zones
- Deploy a protection engine for NAS asset protection
- Add a centralized protection policy for NAS assets
- Cancel a NAS protection job
- Protection rules
- Extended retention for protection policies created in PowerProtect Data Manager 19.11 or earlier
- Exclusion filters for NAS
- Restore a NAS asset to the original location
- Restore a NAS asset to an alternate location
- NAS file level restore using File Search
- Restore PowerScale top-level path and permissions
- Protection engine parameters
- Determine protection engine usage for a protection job
- Change the protection engine Docker network range
- Network-Attached Storage Best Practices and Troubleshooting
- Glossary
PowerProtect Data Manager 19.15 Network-Attached Storage User Guide
Resolved limitations
Observe the following information when planning NAS protection:
- PowerProtect Data Manager 19.12 and later releases support the automatic discovery and protection of shares which are part of all access zones for PowerScale. In the previous releases, the support is limited to System access zone.
- NAS backups support FLR from backups on remote (replicated) protection storage or from backups in a Cloud Tier objective.
- PowerProtect Data Manager 19.15 supports folder path with 1024 characters when creating an exclusion filter with a folder path.
- In PowerScale appliances, PowerProtect Data Manager supports file path or folder path with 1024 characters. The user can perform the backup and restore operations.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\