- Notes, cautions, and warnings
- Preface
- PowerProtect Data Manager for Storage Arrays Overview
- Managing Assets and Protection
- About asset sources, assets, and storage
- Enable the storage array asset source
- Add a storage array
- Edit or delete a storage array asset source
- Protection policies for block volume protection
- Supported protection policy purposes
- Supported protection policy objectives
- Replication triggers
- Roadmap for planning a protection policy
- Before you add a protection policy for block volume protection
- Add a protection policy for block volume protection
- Create a manual snapshot
- Protection rules
- Restoring block volume data
- Restore a block volume using Instant Access
- Troubleshooting
- Glossary
PowerProtect Data Manager 19.14 Storage Array User Guide
PowerStore limitations
Review the following limitations that apply to PowerStore:
- Restores of an individual volume from a volume group backup are not supported.
- If a backup is taken within 1 hour of the previous backup, the job statistics may report the cumulative value from the previous backup.
- Sometimes, bytes transferred is shown as zero for backup and restore jobs.
- Instant Access is not supported from a replicated backup copy. Instant Access is only supported for a remote snapshot or backup from the same storage unit where it was backed up originally.
- Instant Access is not supported when other backups and restores are in progress.
- Instant Access is supported for all block resources except VMware VMFS datastores.
NOTE:These limitations originate from PowerStore. Future updates to the PowerStore software may affect limitations on PowerProtect Data Manager functionality.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\