If you want to remove an asset source that you no longer require, perform the following steps to delete the asset source in the
PowerProtect Data Manager UI.
About this task
NOTE: Do not manually run the
unConfigureAddOn.sh or
unregister.sh command from the host. When the asset source deletion is initiated from
PowerProtect Data Manager, the
unregister and
unconfigure commands are run automatically.
Only the
Administrator role can manage the asset sources.
Steps
From the
PowerProtect Data Manager UI, select
Infrastructure > Asset Sources, and then select the tab for the type of asset source that you want to delete.
Select the asset source name in the asset source list, and then click
Delete.
At the warning prompt that appears, click
Continue.
The asset source is deleted from the list.
Results
PowerProtect Data Manager removes the specified asset source in the
Asset Sources window.
Any associated assets that are protected by the protection policy are removed from the protection policy and their status is changed to
deleted. These assets are removed automatically as part of daily
PowerProtect Data Manager cleanup after all associated backup copies have been deleted. These assets can also be removed manually. The
PowerProtect Data Manager Administrator Guide provides details on how to remove assets from
PowerProtect Data Manager.
In the
PowerProtect Data Manager UI, to list the assets with the deleted status, use the appropriate filter option.
The copies of assets from the asset source are retained (not deleted). You can delete the copies from the copies page, if required.
For an asset that was previously protected by
PowerProtect Data Manager, regular compliance deletion runs until all the backup pieces are expired.
Existing backup copies that were generated before the client was added to
PowerProtect Data Manager are not deleted from the PowerProtect DD storage unit. To delete the Application Direct backup pieces, you must run a regular stand-alone
ddutil command:
To delete the Oracle Incremental Merge backup pieces that were generated before the client was added to
PowerProtect Data Manager, use the
ddutil command according to instructions in the
PowerProtect Oracle RMAN Agent Administration Guide (for the stand-alone Oracle RMAN agent). In that guide, refer to the "Oracle Incremental Merge operations" section and the topic about using the
ddutil command to list and delete the backups.
For backup copies that
PowerProtect Data Manager generates,
PowerProtect Data Manager performs deletion of the copies based on the specified retention.
In the both cases, the backup administrator must perform the catalog cleanup by using the RMAN maintenance commands, such as the
crosscheck and
delete expired commands.
NOTE:In an Oracle RAC cluster, when the active node is down, you must use the asset source deletion option to delete that particular node from
PowerProtect Data Manager. This asset source deletion ensures that the
PowerProtect Data Manager operations run automatically from the next available node.
Data is not available for the Topic
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\