- Notes, cautions, and warnings
- Preface
- PowerProtect Data Manager for Network Attached Storage Overview
- Managing Assets and Protection
- About NAS protection
- Enable the NAS asset source
- Add a NAS appliance
- Add a NAS share
- Edit or delete a NAS asset source
- Deploy a protection engine for NAS asset protection
- Add a centralized protection policy for NAS assets
- Restore a NAS asset to the original location
- Restore a NAS asset to an alternate location
- NAS file level restore using File Search
- Protection engine parameters
- Determine protection engine usage for a protection job
- Change the protection engine Docker network range
- Network Attached Storage Best Practices and Troubleshooting
PowerProtect Data Manager 19.10 Network Attached Storage User Guide
Enable Isilon/PowerScale basic authentication
For Isilon/PowerScale 9.2, basic authentication is disabled by default. Before you add an Isilon/PowerScale appliance, enable basic authentication through the appliance console.
Steps
-
Connect to the Isilon/PowerScale console.
The Isilon OneFS CLI Administration Guide provides instructions.
-
Enable basic authentication:
isi_gconfig -t web-config auth_basic=true
Privilege elevation with sudo may be required, depending on the user permissions and appliance configuration.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\