- Notes, cautions, and warnings
- Preface
- PowerProtect Data Manager File System Agent Overview
- Enabling the File System Agent
- About the File System agent
- Application agent and File System agent coexistence
- File System agent prerequisites
- File System agent limitations
- Block-based backups
- Best practices for file system backups
- Configure the file system parallel backup setting
- Configure asset multi-streaming for file-based backups
- Protect an asset with the File System agent
- Protect an asset in a Microsoft Windows Server clustered environment with the File System agent
- Installing and uninstalling the File System agent on AIX
- Installing and updating the File System agent on Linux
- Installing and updating the File System agent on Windows
- Manage the PowerProtect agent service
- Managing Storage, Assets, and Protection
- Manage the File System agent
- Add protection storage
- Enable an asset source
- Discover a file system host
- Adding a protection policy for File System protection
- Cancel a File System agent backup or restore job
- Add a service-level agreement
- Extended retention
- Edit the retention period for backup copies
- Delete backup copies
- Exclusion filters
- Centralized restore of a file system asset
- Enable the File System agent after hostname change
- Performing Self-Service Backups and Restores with the File System Agent
- Performing Disaster Recovery with the File System Agent in Windows
- Disaster recovery limitations
- Preparing for disaster recovery
- Performing system-state recovery
- Recovering the Active Directory
- Performing bare-metal recovery
- Performing a bare-metal recovery of Windows clusters
- Performing application restores after bare-metal recovery
- File System Best Practices and Troubleshooting
PowerProtect Data Manager 19.10 File System User Guide
Install the File System agent on AIX in silent mode
On AIX, review the following commands to perform a silent installation of the File System agent.
NOTE
The --server option is used to specify the PowerProtect server IP for registration, and is mandatory for silent install.
Use the following commands to perform a silent installation on AIX:
- For silent installation, including registration of the agent with the PowerProtect server, type: install.sh --silent-install --server=<PowerProtect_server_IP>
- To run the installer in debug mode during silent installation, type: install.sh --debug --silent-install --server=<PowerProtect_server_IP>
- To skip installation of the block-based backup driver, type: install.sh --skip-driver --silent-install --server=<PowerProtect_server_IP>.
- To enable the PowerProtect Data Manager communication 7000 TCP port, run the /opt/dpsapps/agentsvc/configfw.sh script as the root user.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\