- Notes, cautions, and warnings
- Preface
- Getting Started
- Preparing for a Deployment
- Licensing PowerProtect Data Manager
- PowerProtect Data Manager interoperability introduction
- Microsoft application agent, Oracle RMAN agent, and PowerProtect Data Manager interoperability
- File System agent interoperability and supported operating systems
- Memory optimization
- Scalability limits for vCenter server, VM Direct Engine, and DD systems
- PowerProtect Data Manager resource requirements in a VMware environment
- Requirements for an external VM Direct Engine
- Requirements for the PowerProtect Search Engine
- Network requirements
- Deployment
- Configuration
- Performing Updates
- Managing update packages
- Updating the version of PowerProtect Data Manager
- Update PowerProtect Data Manager from version 19.9 to version 19.10
- Update PowerProtect Data Manager from version 19.8 to version 19.10
- Update PowerProtect Data Manager from version 19.7 to version 19.10
- Update PowerProtect Data Manager from version 19.6 to version 19.10
- Updating PowerProtect Data Manager to version 19.10 or later in a Kubernetes environment
- Deployment Best Practices and Troubleshooting
PowerProtect Data Manager 19.10 Deployment Guide
Lockbox passphrase required when updating from some versions
In some circumstances, the lockbox passphrase is required to proceed with an PowerProtect Data Manager update.
The following table identifies whether the lockbox passphrase is required when updating to version 19.10, depending on the
PowerProtect Data Manager version you are updating from.
| Updating from version | Lockbox passphrase required? |
|---|---|
| 19.6 | No |
| 19.7 | Yes, if you have not previously updated the system and accepted the update-package certificate. Otherwise, no. |
| 19.8 or later | No |
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\