Skip to main content
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Enjoy members-only rewards and discounts
  • Create and access a list of your products

PowerProtect Data Manager 19.10 Cloud Disaster Recovery User Guide

Add a Policy type Service Level Agreement

The SLA Compliance window in the PowerProtect Data Manager UI enables you to add a service level agreement (SLA). The Service Level Agreement identifies your Service Level Objectives (SLOs). You can use the SLOs to verify that your protected assets are meeting the Service Level Agreements (SLAs).

Steps

  1. Select Protection > SLA Compliance.
    The SLA Compliance window appears.
  2. Click Add button. The Add Service Level Agreement wizard opens.
  3. Select Cloud DR in the Type section, and then click Next.
  4. In the Objectives section, specify the following fields:
    1. The SLA name.
    2. Select Minimum Independent Copies, and specify the number of Cloud DR backups.
    3. Select Maximum Independent Copies, and specify the number of Cloud DR backups.
    4. Select Available Location, and specify the locations where Cloud DR backups are located.
      Use the Add Location option to add new locations that unavailable in locations list.
      Enable Allowed in Cloud through Cloud Tier/Cloud DR checkbox to enable the availability of the backups in the cloud.
  5. Click Finish.
    The SLA is displayed on the SLA Compliance page.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\