Whether you are installing Index Engines CyberSense software for the first time or updating from a previous version along with the
Cyber Recovery software, the workflows described in the following sections explain how to perform the installation or update properly.
Initial installation workflow
NOTE:You must install the software to the following required minimum versions:
CyberSense 8.2
Cyber Recovery 19.13
For the first installation of the Index Engines CyberSense and
Cyber Recovery software, see the following workflow:
Install the Index Engines CyberSense software using the procedures described in the
Index Engines CyberSense Initial Setup and Configuration Guide.
Install the
Cyber Recovery software, using the procedures described in the
Dell PowerProtect Cyber Recovery Installation Guide. Then, configure your Cyber Recovery deployment and create:
Policies
Copies for analysis
Multilink definitions
On the Index Engines CyberSense engine, assign DD Boost users to multilink definitions described in the
Configuring DD Boost users section of the
Index Engines CyberSense Initial Setup and Configuration Guide.
Update workflows
When you are updating the Index Engines CyberSense and
Cyber Recovery software, you must update to at least the following required minimum versions:
CyberSense 8.2
Cyber Recovery 19.13
Two common scenarios for updating the
Cyber Recovery software and CyberSense software include:
Updating both the
Cyber Recovery software and the CyberSense software
Updating the
Cyber Recovery software and installing the CyberSense software
Updating from earlier versions
If you already have versions of CyberSense and
Cyber Recovery software installed in your deployment, do the following:
On the Index Engines engine, add DD Boost users by using the Index Engines ddboostcfg tool.
Update the CyberSense software to at least version 8.2. See the
Upgrading the Index Engines software section of the
Index Engines CyberSense Initial Setup and Configuration Guide.
NOTE:If you have not added DD Boost users, the update fails.
Update the
Cyber Recovery software to at least version 19.13. See the
Dell PowerProtect Cyber Recovery Installation Guide.
NOTE:After the
Cyber Recovery update, if analyze schedules exist, the software automatically creates multilink definitions. It also imports the DD Boost users that were added in step 1, allowing the multilink definitions to be active.
Updating
Cyber Recovery and installing CyberSense
If you are updating the
Cyber Recovery software to version 19.13 or higher and installing CyberSense version 8.2 or higher, follow the procedure under the
Initial Installation workflow section, updating the
Cyber Recovery software in step 2 of the procedure.
Data is not available for the Topic
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\