Run the
crsetup.sh script to install, manage, verify, and remove the
Cyber Recovery software. Other options enable functions for management and troubleshooting. This topic provides a reference for the options used in the procedures in this guide.
Syntax
crsetup.sh<option>
Options
The following options, including the corresponding flags, determine the result of the
crsetup.sh script.
--addcustcert,
-y
Add the custom CA-signed certificates to the
Cyber Recovery system
--address,
-a
Update the IP address of the
Cyber Recovery management host
--changepassword,
-w
Change the passphrase or password for the
Cyber Recovery lockbox, MongoDB, and the Security Officer (crso)
--check,
-c
Run the configuration check to validate proper installation requirements
--deploy,
-d
Configure the
Cyber Recovery software (OVA Only)
--forcecreate,
-f
Force recreation of the
Cyber Recovery containers
--gencertrequest,
-j
Generate a certificate-signed request (CRSERVICE.csr) file
--help,
-h
Display the help content
--install,
-i
Install the
Cyber Recovery software
--irprop,
-t
Display the IR script information for
Cyber Recovery configuration
--recover,
-r
Recover the
Cyber Recovery software
--restart,
-e
Stop and then start all services.
--save,
-b
Save the
Cyber Recovery software configurations
--start,
-s
Start the
Cyber Recovery software
--stop,
-p
Stop the
Cyber Recovery software
--uninstall,-x
Uninstall the
Cyber Recovery software
--upgcheck,
-k
Run a pre-update readiness check
--upgrade,
-u
Update the Cyber Recovery software
--verifypassword,
-v
Verify the lockbox passphrase and the MongoDB and crso passwords.
Data is not available for the Topic
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\