- Notes, cautions, and warnings
- Before working inside your Embedded Box PC
- After working inside your Embedded Box PC
- Technical overview
- Removing the back cover
- Replacing the back cover
- Removing the hard drive
- Replacing the hard drive
- Removing the solid-state drive
- Replacing the solid-state drive
- Removing the interposer board
- Replacing the interposer board
- Removing the solid-state drive card bracket
- Replacing the solid-state drive card bracket
- Removing the SIM card
- Replacing the SIM card
- Removing the memory module
- Replacing the memory module
- Removing the WLAN card
- Replacing the WLAN card
- Removing the WWAN card
- Replacing the WWAN card
- Removing the CANbus cable
- Replacing the CANbus cable
- Removing the CANbus card
- Replacing the CANbus card
- Removing the intrusion switch
- Replacing the intrusion switch
- Removing the I/O plate
- Replacing the I/O plate
- Removing the WLAN-antenna connectors
- Replacing the WLAN-antenna connectors
- Removing the WWAN-antenna connectors
- Replacing the WWAN-antenna connectors
- Removing the IET board
- Replacing the IET board
- Removing the top cover
- Replacing the top cover
- Removing the coin-cell battery
- Replacing the coin-cell battery
- Removing the system board
- Replacing the system board
- Removing the Dell logo board
- Replacing the Dell logo board
- BIOS setup program
- Technology and components
Dell Embedded Box PC3000Service Manual
After working inside your Embedded Box PC
- Replace all screws and ensure that no stray screws remain inside the Embedded Box PC.
- Connect any external devices, peripherals, or cables you removed before working on the Embedded Box PC.
- Connect your Embedded Box PC and all attached devices to their electrical outlets.
- Turn on the Embedded Box PC.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\