Re-setting
the Dell Wireless Docking Station WLD15
To re-set
to the default factory settings, first power off the docking station,
press the re-set button for more than 2 seconds, and then power on
the docking station.
Figure 1. Reset
The Reset button is intended for recovering from
undesired situations. It restores default parameters and the factory
firmware version. The table below describes the reset button functionality:
Function
Action
Effect
Parameters recovery
Long press (>2 sec)
Restores all parameters to factory defaults.
NOTE: The firmware version
is not changed in this process.
Factory version recovery and defaults
Press during docking station power-up.
Restores factory-saved version.
NOTE: This process will restore
the firmware version, restore all default parameters, and delete all
previously defined profiles.
Data is not available for the Topic
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\