OpenManage Enterprise 4.0.x User's Guide

Create a remote command job for managing devices

Create a job to remotely run a command and control devices.

1. Click Create > Remote Command on Devices.
2. In the Command Line Job wizard dialog box, in the Options section:
   1. Enter the job name in Job Name.
   2. From the Interface drop-down menu, select one of the interfaces depending on the target devices you want to manage:
      • IPMI CLI is used for iDRACs and non-Dell servers.
      • RACADM CLI is used for iDRACs discovered using the WSMAN protocol.
      • SSH CLI is used for Linux servers discovered using the SSH protocol.
   3. In the Arguments box, enter the command. Up to 100 commands can be typed with each command that is required to be on a new line.
      NOTE:The commands in the Arguments box are run one at a time.
   4. Click Next.
      A green tick mark next to Options indicates that the necessary data is provided.
3. In the Target section, select the target devices and click Next. See Select target devices and device groups.
4. In the Schedule section, run the job immediately or schedule for a later time. See Schedule job field definitions.
5. Click Finish.