Device Overview
- On the
<device name> page, under
Overview, the health, power status, and Service Tag of the device is displayed. Click the IP address to open the iDRAC login page. See the
iDRAC User's Guide available on the Dell support site.
- Information: Device information such as Service Tag, DIMM slots, iDRAC DNS name, processors, chassis, operating system, and data center name. Multiple management IP addresses correlated to the device are listed and can be clicked to activate the respective interfaces.
- Recent Alerts: The recent alerts generated for the device.
- Recent Activity: A list of recent jobs run on the device. Click View All to view all the jobs. See Using jobs for device control.
- Remote Console: Click Launch iDRAC to start the iDRAC application. Click Launch Virtual Console to start the virtual console. Click the Refresh Preview symbol to refresh the Overview page.
- Server Subsystem: Displays health status of other components of the device such as PSU, fan, CPU, and battery.
NOTE The time taken to collect subsystem data of sensor components discovered using IPMI depends on network connectivity, target server, and target firmware. If you experience timeouts while collecting the sensor data, reboot the target server.
- The Last Updated section indicates the last time when the device inventory status was updated. Click the Refresh button to update the status. An Inventory job is started and the status is updated on the page.
-
By using Power Control, turn on, turn off, power cycle, and gracefully shut down a device.
- By using
Troubleshoot:
- Run and download the Diagnostics report. See Run and download Diagnostic reports.
- Reset iDRAC.
- Extract and download the Services (SupportAssist) report. See Extract and download Services (SupportAssist) reports.
- Refresh the device status.
- Refresh the device inventory.
- Export the device inventory that is collected by clicking Refresh Inventory. See Export all or selected data.
- Run a remote RACADM, and IPMI command on the device. See Run remote–RACADM and IPMI–commands on individual devices.
OpenManage Enterprise provides a built-in report to get an overview of devices monitored by OpenManage Enterprise. Click Run reports.
. Click Run. See