Dell OpenManage Deployment Toolkit Version 5.4 Command Line Interface Reference Guide

PDF

pefcfgparams

Table 1. pefcfgparamsThe following table describes the option, sub-option, valid arguments and descriptions for the pefcfgparams.
Option	Sub-option	Valid Arguments	Description
pefcfgparams or pcp			Configures and displays PEF configuration parameters. This option can be replicated.
	--filter	fanfail, voltfail, discretevoltfail, tempwarn, tempfail, intrusion, redundegraded,redunlost, procwarn, procfail, powerwarn, powerfail, hardwarelogfail, autorecovery, batterywarn, batteryfail, powerabsent, procabsent, systempowerwarn, systempowerfail	Specifies a PEF value. This sub-option can be replicated. For a complete list of all possible PEF messages along a description of each event, see BMC Platform Events Filter Alert Messages
	--filteraction	powercycle, reset, powerdown, power reduction, none	Sets the event filter action for the filter specified using the filter sub-option. This sub-option depends on the filter sub-option. This sub-option can be replicated.
	--hostname	<string>	Sets the host name (maximum of 62 printable ASCII characters) for the BMC. This sub-option can be replicated. The hostname string must comprise only the followig characters: hyphen (-) , underscore (_) , and period (.) .
	--filteralert	enable, disable	Enables or disables alerts for the filter specified using the filter sub-option. This sub-option is dependent on the filter sub-option. This sub-option can be replicated.
	--alertpolnum	1, 2, 3, 4	Specifies the alert policy entry number. This sub-option can be replicated.
	--alertpolstatus	enable, disable	Enables or disables the alert policy specified using the alertpolnum sub-option. This sub-option can be replicated. This sub-option is dependent on the alertpolnum sub-option. Example: (to set the PEF configuration parameters): Example 1 (To configure the PEF so that the system is powered down in response to a fan failure event): A:>syscfg pefcfgparams --filter= fanfail--filteraction=powerdown pefcfgparams filter=fanfail filteraction=powerdown Example 2 (To configure the PEF so that a PEF alert is not sent to the destination IP address in response to a chassis intrusion event): A:>syscfg pefcfgparams --filter= intrusion--filteralert=disable pefcfgparams filter= intrusion filteralert=disable