Optionally,
Image Assist allows you to capture a Reference image that can be used as a snapshot or restore point. This image is not Syspreped and is not valid for factory use. When you are restoring a Reference image, there is no option to select drivers.
Steps
On the
Image Assist home page, click
and click
Additional Tools.
In the
Capture Reference Image card, click
CAPTURE.
The
Prepare Reference Capture page is displayed.
Click
RUN to capture the Reference image.
After the capture process is complete, the system is restarted and the
Capture Dynamic Image page is displayed.
To auto capture the image, click
CAPTURE IMAGE or wait for the capture process to start automatically.
To modify the capture settings, click
CANCEL before the countdown ends.
After the image is captured, a confirmation window is displayed.
Click
COPY to save the WIM file to a USB drive or to a different location.
NOTE:You must test the image before you submit it to Dell factory. For more information, see
Restore and test image.
NOTE:To automate the restore process, save the dynamic image in the
Dell_Images folder, and the driver packs in the
Dell_Driver_Packs_Local folder.
Note the path where the file is saved and click
SHUT DOWN to turn off the system.
Data is not available for the Topic
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\