You can configure Multi Display using Device Settings.
Multi Display configurations are enabled when more than one monitor are connected.
Figure 1. With Single MonitorFigure 2. With Dual MonitorsFigure 3. With Three Monitors
NOTE:Mirror Mode and
Single Display Mode are active only when your device is connected with two monitors. When a monitor is more than one, then only Multi Display setting can be configured using Device Settings.
You can configure the following settings:
Display Mode:
Display Mode is active when you connect more than one monitor.
Three Display modes are available in Device settings for you to select based on the use case.
Figure 4. Display Mode
Join Display:
When two or more monitors are connected, you can use
Join Displays mode and configure Primary display, Monitor Position, Orientation, Resolution, and Scaling.
You can move display in the Drag and display box to match the physical display setup.
Figure 5. Join Display
Mirror:
Mirror mode is active once you connect two monitors. The connected monitors are mirrored.
Figure 6. Mirror
NOTE:Mirror mode supported only two monitors. When more than two monitors are connected, Join Display or Multi Monitor mode is active.
Single Display:
You can configure a
Single Display mode when two monitors are connected. In this case, the primary monitor is active and the secondary monitor is blank or in Turned Off state.
Figure 7. Single Display
Data is not available for the Topic
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\
NOTE:Mirror mode supported only two monitors. When more than two monitors are connected, Join Display or Multi Monitor mode is active.