Dell Hybrid Client version 2403 Administrator's Guide

Configure the Imprivata as Connection mode

Configure the VDI settings on the Imprivata OneSign Server Web Console.
Configure the computer policies on the Imprivata OneSign server.
Configure the authentication type—username and password or smart card—on the Imprivata OneSign server.
Ensure that you have installed valid certificates that are required to connect to the Imprivata session. For more information about installing certificates, see Install a certificate.
Ensure that you have given DNS.

This section describes the procedure to configure the global connection settings for Imprivata using Wyse Management Suite.

Log in to Wyse Management Suite.
Go to the Groups & Configs page, and select your preferred device group.
The Imprivata settings are available only for device-level group policy.
Click Edit Policies > Dell Hybrid Client 2.x.
The Configuration Control | Dell Hybrid Client 2.x page is displayed.
Click the Advanced tab.
Expand Login Experience, and click 3rd Party Authentication.
From the Authentication Type drop-down list, select Imprivata.
Configure the following Imprivata session options as per your requirement:
- Bootstrap Server—Enter the Bootstrap appliance name or the IP address.
- Mainloader server same as Bootstrap—Enable this option to keep the mainloader server the same as the Bootstrap server.
  NOTE:If you disable this option, you must provide the Mainloader server appliance name or the IP address.
- Agent server same as Bootstrap—Enable this option to keep the Agent server the same as the Bootstrap server.
  NOTE:If you disable this option, you must provide the Agent server appliance name or the IP address.
- Connection Mode—Enable this option to use Imprivata in connection mode.
NOTE:Imprivata does not support Ubuntu 22.04 .

NOTE:CA Certificate Mandatory is for Imprivata.