Skip to main content
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Enjoy members-only rewards and discounts
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.

Dell SmartFabric OS10 User Guide Release 10.5.3

PDF

sync-e enable

Enables Synchronous Ethernet (SyncE) globally on a switch or on a physical interface.

Syntax
[no] sync-e enable
Parameters
None
Default
Disabled
Command Mode
  • CONFIGURATION
  • INTERFACE CONFIGURATION
Security and Access
Netadmin and sysadmin
Usage Information
When you enable SyncE globally on a switch, it is enabled by default in the QL-Disabled mode. Enabling SyncE on interfaces permits the clock sources that are connected to those interfaces to participate in the clock selection process. You can enable SyncE only on the physical interfaces. The no form of this command removes the configuration.
Example - Enable SyncE globally
OS10(config)# sync-e enable
Example - Enable SyncE on a physical interface
OS10(config)# interface ethernet 1/1/1
OS10(conf-if-eth1/1/1)# sync-e enable
Supported Releases
10.5.2.1 or later

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\