Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Enjoy members-only rewards and discounts
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Sign In Create an Account Dell Financial Services Premier Sign In Partner Program Sign In
Contact Us

Your Dell.com Carts

Dell SmartFabric OS10 User Guide Release 10.5.3

PDF

show sync-e esmc

Displays the ESMC information of all interfaces.

Syntax
show sync-e esmc
Parameters
None
Default
None
Command Mode
EXEC
Usage Information
This command prints the output of the interfaces only if ESMC and SyncE are enabled on the interfaces and SyncE is enabled globally.
Example 
OS10# show sync-e esmc
Codes: EEC # - Number of cascaded  EECs, eEEC # - Number of cascaded eEECs
------------------------------------------------------------------------------------------
Interface     Mode      QL Rx      QL Tx    Clock Source Identity    Lag   EEC # eEEC #
                                                                     Name
------------------------------------------------------------------------------------------
Eth1/1/5    Disabled       -         -                -               -     0      0
Eth1/1/1    Rx and Tx   QL-SSU-A   QL-PRC   3c:2c:30:ff:fe:04:07:00  po1    0      1
Ethl/1/2    Rx and Tx   QL-SSU-A   QL-PRC   3c:2c:30:ff:fe:04:07:00  po1    0      2
Ethl/1/3    Rx and Tx   QL-PRC     QL-DNU   3c:2c:30:ff:fe:04:07:00  po1    0      2
Ethl/1/4    Rx and Tx   QL-SSU-B   QL-DNU   3c:2c:30:ff:fe:04:07:00  po1    0      1
------------------------------------------------------------------------------------------
Supported Releases
10.5.2.1 or later

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\