Skip to main content
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Enjoy members-only rewards and discounts
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.

Dell SmartFabric OS10 User Guide Release 10.5.3

PDF

show ip ospf asbr

Displays all the ASBR visible to OSPF.

Syntax
show ip ospf [process-id] [vrf vrf-name] asbr
Parameters
  • process-id—(Optional) Displays information based on the process ID.
  • vrf vrf-name — (Optional) Displays the ASBR router visible to the OSPF process configured in the specified VRF.
Default
Not configured
Command Mode
EXEC
Usage Information
You can isolate problems with external routes. External OSPF routes are calculated by adding the LSA cost to the cost of reaching the ASBR router. If an external route does not have the correct cost, this command determines if the path to the originating router is correct. ASBRs that are not in directly connected areas display. You can determine if an ASBR is in a directly connected area by the flags. For ASBRs in a directly connected area, E flags are set.
Example
OS10# show ip ospf 10 asbr

RouterID         Flags    Cost   Nexthop         Interface    Area
112.2.1.1        E/-/-/   1      110.1.1.2       vlan3050    0.0.0.0
111.2.1.1        E/-/-/   0      0.0.0.0         -             -
Supported Releases
10.2.0E or later

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\