Skip to main content
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Enjoy members-only rewards and discounts
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.

Dell SmartFabric OS10 User Guide Release 10.5.3

PDF

sflow collector

Configures an sFlow® collector IP address where sFlow® datagrams are forwarded. You can configure a maximum of two collectors.

Syntax
sflow collector {ipv4-address | ipv6-address} agent-addr {ipv4-address | ipv6-address} [collector-port-number] [max-datagram-size datagram-size-number][vrf vrf-name]
Parameters
  • ipv4-address | ipv6-address — Enter an IPv4 or IPv6 address in A.B.C.D/A::B format.
  • agent-addr ipv4-address | ipv6-address — Enter the sFlow® agent IP address. If you configure two collectors, the agent IP address must be the same for both the collectors.
  • collector-port-number — (Optional) Enter the UDP port number, from 1 to 65535. The default is 6343.
  • max-datagram-size datagram-size-number — (Optional) Enter max-datagram-size then the size number in bytes, from 400 to 1500. The default is 1400.
  • vrf — (Optional) Enter the VRF instance to set the VRF context to the collector IP address. If you do not specify a VRF, the system uses the default VRF.
Defaults
Not configured
Command Modes
CONFIGURATION
Usage Information

You must enter a valid and reachable IPv4 or IPv6 address. If you configure two collectors, traffic samples are sent to both. The sFlow® agent address is the IPv4 or IPv6 address used to identify the agent to the collector. The no version of this command removes the configured sFlow® collector.

If you specify a nondefault VRF, create the VRF first.

Example
OS10(conf)# sflow collector 10.1.1.1 agent-addr 2.2.2.2 6343 max-datagram-size 1500 vrf default
OS10(conf)# sflow collector 10.1.1.1 agent-addr 2.2.2.2 6343 max-datagram-size 1500 vrf vrf-core
Supported Releases
10.3.0E or later. Updated the command to specify a nondefault VRF on OS10 release 10.4.3.0 or later

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\