Skip to main content
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Enjoy members-only rewards and discounts
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.

Dell SmartFabric OS10 User Guide Release 10.5.3

PDF

r_a_tov

Configures the R_A_TOV FC timer value for vfabric.

Syntax
r_a_tov timeout-val
Parameters

timeout-val—Valid values are from 5000 to 10000.

Defaults
10000ms
Command Mode
VFabric CONFIGURATION
Usage Information
  • The configurations are supported only in multiswitch mode.
  • This timer is used to mark the error conditions during domain ID allocation, SW-RSCN, and NS QUERY. Match this value with the other end, during port initialization. This type of configuration is not permitted when vfabric is active.
  • If the configured R_A_TOV value is not the same on both the sides of the port, then the port is isolated. Ensure to configure the same R_A_TOV value on both the sides.
  • You can change the R_A_TOV value only when vfabric is in inactive state. You can activate the vfabric only by adding VLAN and fcmap configuration under the vfabric configuration view. Ensure to configure the R_A_TOV before configuring the vlan, and fcmap in the vfabric configuration view.
  • The no version of this command resets to default value of 10000ms.
Example
OS10(conf-vfabric-<vfabric-id>)#r_a_tov 3000
Supported Releases
10.5.1.0 or later

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\