Skip to main content
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Enjoy members-only rewards and discounts
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.

Dell SmartFabric OS10 User Guide Release 10.5.3

PDF

ptp egress-delay-asymmetry

Configures delay asymmetry to offset the static delay on a PTP egress path.

Syntax
[no] ptp egress-delay-asymmetry egress-delay-value
Parameters
egress-delay-value—Enter the egress delay asymmetry value in nanoseconds. The supported values are from -9,223,372,036,854,775,808 to 9,223,372,036,854,775,807.
Defaults
0
Command Mode
INTERFACE CONFIGURATION
Security and Access
Netadmin and sysadmin
Usage Information
The egress delay asymmetry value is applicable only in slave mode. This configuration is applicable only to Layer 2, IPv4, and IPv6 multicast peers. The no form of this command removes the configuration.
Example (system default profile)
OS10(config)# interface ethernet 1/1/1
OS10(conf-if-eth1/1/1)# ptp egress-delay-asymmetry 67
Supported Releases
10.5.3.0 or later

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\