Skip to main content
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Enjoy members-only rewards and discounts
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.

Dell SmartFabric OS10 User Guide Release 10.5.3

PDF

private-vlan mode (Port mode)

Configures PVLAN port mode.

Syntax
private-vlan mode {promiscuous | secondary-port}
Parameters
  • promiscuous—Configures the port as a promiscuous port.
  • secondary-port—Configures the port as a secondary port.
Default
None
Command Mode
INTERFACE CONFIGURATION
Usage Information
  • This command is applicable only for physical and port channel interfaces. Configures an interface as one of the following PVLAN ports:
    • Promiscuous port: Depending on the Switchport mode configuration, this port can be an Access or a Trunk port.
    • Secondary port: A secondary port can be an isolated or a community port. Depending on the Switchport mode configuration, this port can be an Access or a Trunk port.
  • This configuration takes effect only when this interface is associated with a PVLAN. Unless this interface is associated with a PVLAN, it continues to function as a normal access or trunk port.
  • The no form of this command removes PVLAN port mode.
NOTE: If this port is a member of a primary or secondary VLAN, you cannot configure or reset PVLAN port mode.
Example—To configure an interface as PVLAN promiscuous port.
OS10(config)# interface port-channel20
OS10(conf-if-po-20)# private-vlan mode promiscuous
OS10(conf-if-po-20)#exit
OS10(config)# interface ethernet 1/1/5
OS10(conf-if-eth1/1/5)# private-vlan mode promiscuous
Example—To configure an interface as a secondary port.
OS10(conf-if-po-20)# private-vlan mode secondary-port
OS10(conf-if-po-20)# no private-vlan mode
Example—To configure a secondary port as a trunk port.
OS10(config)# interface port-channel20
OS10(conf-if-po-20)# switchport mode trunk
OS10(conf-if-po-20)# private-vlan mode secondary-port
Example—To configure a promiscuous port as a trunk port.
OS10(conf-if-po-20)# switchport mode trunk
OS10(conf-if-po-20)# private-vlan mode promiscuous
Supported Releases
10.5.2.0 or later

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\