Skip to main content
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Enjoy members-only rewards and discounts
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.

Dell SmartFabric OS10 User Guide Release 10.5.3

PDF

multicast peer-routing-timeout

Configures the time duration for a VLT node to retain synchronized multicast routes if there is a VLT peer node failure.

Syntax
multicast peer-routing-timeout value
Parameters
value—Enter the timeout value in seconds, from 1 to 1200.
Default
300 s
Command Mode
VLT-DOMAIN
Usage Information

If one of the VLT peer nodes goes down, the multicast peer-routing timer starts. When the multicast peer-routing timer expires, the system removes any stale routes that were retained at the time the peer went down, but were not converged. The routes that are not locally learned and the routes that are not resynchronized from the peer, or both, are removed.

NOTE: Dell Technologies recommends that you configure the same timeout value on both the VLT peer nodes.

The no form of this command resets the multicast peer-routing timer value to its default value of 300 s.

Example
OS10(config)# vlt-domain 255
OS10(conf-vlt-255)# multicast peer-routing-timeout 1200
Supported Releases
10.5.2.0 or later

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\