Skip to main content
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Enjoy members-only rewards and discounts
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.

Dell SmartFabric OS10 User Guide Release 10.5.3

PDF

match ra

Verifies the source IPv6 address, prefix address, and the source MAC address of the inspected messages.

Syntax
match ra {ipv6-access-list | ipv6-prefix-list | mac-access-list} name
Parameters
  • ipv6-access-list name—Enter ipv6-access-list and the name of the access list.
  • ipv6-prefix-list name—Enter ipv6-prefix-list and the name of the prefix list.
  • mac-access-list name—Enter mac-access-list and the name of the MAC access list.
Default
None
Command Mode
RA GUARD POLICY LIST CONFIGURATION
Usage Information
  • If you do not configure this command, the system bypasses the verification process.
  • If you configure all three access lists, OS10 matches the inspected packets against all the configured policies.
  • For the IPv6 access list, the system verifies only the IPv6 source address. For the MAC access list, the system verifies only the source MAC address.
NOTE: If you have configured the policy using the match ra command, but not configured the access lists or ACLs, the system bypasses the verification process. Generic ACL behavior applies when the policy is attached to interface.

The no form of this command removes the configuration.

Example
OS10(conf-ra_guard_policy_list)# match ra ipv6-access-list test_access_list
Supported Releases
10.5.2.0 or later

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\